Page 1 of 1
Problem running open loop + PLX M300
Posted: Fri Oct 29, 2004 2:48 am
by CivicVTi
I run open loop and have disabled O2 heater. I get an occasional CEL (primary o2 sensor). Why?
p.s I have not installed a resistor across the o2 heater but I guess disabling O2 heater is equivalent
Posted: Fri Oct 29, 2004 9:42 am
by Spunkster
You still need to install the resistor.
Posted: Fri Oct 29, 2004 10:30 am
by CivicVTi
OK. Thanks. So disabling o2 heater and installing a resistor would do, right?
Posted: Mon Nov 01, 2004 6:03 pm
by highperboi
i have the same problem. So the code 1 throws sometimes means that the o2 is disabled?
Posted: Wed Nov 03, 2004 4:59 pm
by turbosi92
Spunkster wrote:You still need to install the resistor.
This doesn't help. It is a bug in the software. This doesn't happen on the older version of the Rom Editor.
Posted: Thu Nov 04, 2004 1:59 am
by CivicVTi
I guess Hondata should solve it in the forthcoming edition of ROM Editor.
Posted: Thu Nov 04, 2004 8:12 am
by DaX
I think they said they are fixing this in the next release. When is it...sometime around the beginning of 2005?