Page 1 of 1
Analog inputs to fuel table?
Posted: Thu Jan 09, 2025 4:35 pm
by KanoB20v
Hello I'm am try to figure out if there is a way to get my analog inputs to display on fuel tables for fuel adjustments and what not. I have a AEM WIDEBAND 30-4110 . I wired it up to analog input 0 I got it pretty accurate reading to show on "display" but I would like it to show on the fuel table is there anyway to do so with it wired to analog input 0
Re: Analog inputs to fuel table?
Posted: Thu Jan 09, 2025 4:44 pm
by Spunkster
It would be best to use the ECU inputs instead of the analog inputs on the s300 as then it can run closed loop and have full functionality.
Re: Analog inputs to fuel table?
Posted: Thu Jan 09, 2025 5:10 pm
by KanoB20v
Could I get away with just taping the "white" 0-5 volt output from the wideband to the d14 pin or would i have to re wire both ground and power from the wideband to the ecu as well?
Re: Analog inputs to fuel table?
Posted: Thu Jan 09, 2025 5:47 pm
by Spunkster
Power and ground do not matter. You should use D10 instead of D14 as it cannot read the full voltage range.
Re: Analog inputs to fuel table?
Posted: Thu Jan 09, 2025 6:23 pm
by KanoB20v
How will using the d10 impact negatively or the side effects if you will? I just wanna understand before I got tapping in to wires
Re: Analog inputs to fuel table?
Posted: Fri Jan 10, 2025 10:31 am
by Spunkster
There are no side effects. Details can be found in the help file at:
https://hondata.com/help/smanager/wideb ... b=wideband