Page 1 of 1
Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 2:15 pm
by mjalaly
Just to clarify, if I want to datalog oil pressure throughout a run can I wire the AEM oil pressure gauge to either B6 or D12?
From what I understand only the brown wire should be pinned to B6 or D12. Can someone confirm that?
Screenshot_20241121_141247_OneDrive.jpg
Screenshot_20241121_141220_OneDrive.jpg
I will also check to make sure the right capacitors are there.
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 2:18 pm
by Spunkster
You can, but it is for datalogging only and cannot be used for any protections.
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 3:43 pm
by mjalaly
Understood. Can you confirm the wiring is correct?
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 3:51 pm
by Spunkster
No, the white wire must be connected as it is the signal.
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 3:57 pm
by mjalaly
Thanks!
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 4:04 pm
by mjalaly
Brown to B2? Or does another ground work?
Re: Wiring AEM oil pressure gage to S300 V1
Posted: Thu Nov 21, 2024 4:41 pm
by Spunkster
It may not need a signal ground. Try it without it and see if it reads correctly.