Page 1 of 1
no connection with the control unit, at 7000 rpm, when I write logs
Posted: Sat Aug 31, 2024 12:51 am
by WolkovAI
I write logs in third gear, accelerate to the engine cut-off (8600 rpm), logs are written up to 7000 rpm and the Hondata freezes, returning only if pulled out of the USB connector. I changed the laptop, USB cable, nothing helps\
Acura RSX K20k24 Hondata K pro
Re: no connection with the control unit, at 7000 rpm, when I write logs
Posted: Tue Sep 03, 2024 12:14 pm
by Spunkster
Are you using resistor or non-resistor spark plugs?
Re: no connection with the control unit, at 7000 rpm, when I write logs
Posted: Tue May 06, 2025 5:50 am
by WolkovAI
Spunkster wrote: Tue Sep 03, 2024 12:14 pm
Are you using resistor or non-resistor spark plugs?
NGK
IZFR6K11S I don't use a resistor
Re: no connection with the control unit, at 7000 rpm, when I write logs
Posted: Tue May 06, 2025 9:05 am
by Spunkster
Resistor type spark plugs must be used.
Re: no connection with the control unit, at 7000 rpm, when I write logs
Posted: Sun May 18, 2025 7:37 pm
by WolkovAI
Spunkster wrote: Tue May 06, 2025 9:05 am
Resistor type spark plugs must be used.
I removed the board, cleaned it from dust, installed it back, no more problems, works great