Hondata

Can I depin and add a pin in e5 to supply 5v to a fuel pressure sensor or do I just need to tap the current wire? What sensors does vcc3 provide a 5v reference for?

Also, is there any way to use a 5 volt input to datalog a fuel pressure sensor on Hondata v1?

I would recommend tapping the wire.

This cannot be done on the v1 s300.

Thanks, I'm talking about a v1 kpro not s300, maybe you just mistyped though.

The version 1 K-Pro does not have any additional inputs like the version 4 does.