Hondata

I have 3 sensors on analog channels that I'd like to setup to read in the AIM dash, emap, boost pressure, and fuel pressure. I need help calculating the multiplier and offset for the three sensors in AIM Racestudio. I've read a couple threads, but not grasping what I need to do. Thanks!

emap is AEM sensor 30-2130-50
Settings in Kpro
Min voltage .5 volts
Min Pressure -1.01 bar

Max voltage 4.5 volts
Max pressure 2.48 bar

boost and fuel pressure sensor is Honeywell MIPAN2XX100PSAAX
Settings in Kpro
Min voltage 0 volts
Min Pressure 0 bar

Max voltage 4.5 volts
Max pressure 6.89 bar

Correction, the Honeywell sensors should start at .5 volts. For some reason the sensors aren't working in Kpro, I've triple checked my wiring, the sensors are receiving 5 volts from the ECU. What's strange is that when I rename the sensors and then create a new value on the display tab in Kpro the name doesn't pop up when I scroll down to analog inputs, however they do show up for the 3 other sensors I had setup previously. Any help would be appreciated. Thanks!

Boost and fuel pressure sensor is Honeywell MIPAN2XX100PSAAX
Settings in Kpro
Min voltage .5 volts
Min Pressure 0 bar

Max voltage 4.5 volts
Max pressure 6.89 bar

Post the calibration and a datalog showing the issue.