Hondata

Hello,

I have owned and been using Hondata for two decades now, but I am relatively new to K-pro and a little confused about calibration types. I am working on my brothers car, which has a Euro ITR k20 with PRD ecu and v4 K-pro. I want to add a flex fuel sensor, but I saw in the documentation that it is only supported on PRB calibrations.

Can I add Flex Fuel to the PRD ecu? Can I run PRB calibration on the PRD ecu? If the answer is yes to both, how can I tell if my current calibration is based on PRB?

Any clarification would be helpful, I have tried searching for details on this but perhaps I am not looking for the correct terms.

Yes, you can run a PRB calibration on a PRD ECU and use Flex fuel with a flex fuel sensor. You can see the calibration type by opening the calibration and going to the notes in the parameters window.