Hondata

Do we use this guild for the three bar map sensor install http://www.hondata.com/3barinstall.html? Does a GM or AEM 3bar work? How do we tell the difference between the GM, Neetronics, Motec, and AEM map sensors?

A GM sensor will work. It is not exactly what you need but it is close enough. Set the sensor type to the Motec 3 bar and wire in your GM type in the harness like so http://hondata.com/3barinstall.html.

wpayson wrote:A GM sensor will work. It is not exactly what you need but it is close enough. Set the sensor type to the Motec 3 bar and wire in your GM type in the harness like so http://hondata.com/3barinstall.html.

Thanks....Yea I got it working a few weeks ago.

can someone post a new link to this install please.

What's the best 3-bar to use with the K-Series motor? Mark W.