Page 1 of 1
Final tune for the Si
Posted: Tue Aug 15, 2023 10:55 pm
by skymcd
I'll keep this short- 2008 Si with K&N SRI, skunk2 RR exhaust, and Generic headers
I am not doing any more performance mods, just focusing on the handling / suspension side of things. There aren't any dyno tuners in my area so an Etune is my only option.
I'm new to Hondata and tuning in general so just let me know what datalogs I need to take to get the car running strong.
Thanks,
- Skylar.
Re: Final tune for the Si
Posted: Tue Aug 15, 2023 10:59 pm
by skymcd
P.S. it has a K20A2, not the stock K20Z3
Re: Final tune for the Si
Posted: Wed Aug 16, 2023 12:56 pm
by CalibratEd
skymcd wrote: Tue Aug 15, 2023 10:55 pm
I'll keep this short-
2008 Si with K&N SRI, skunk2 RR exhaust, and Generic headers
I am not doing any more performance mods, just focusing on the handling / suspension side of things. There aren't any dyno tuners in my area so an Etune is my only option.
I'm new to Hondata and tuning in general so just let me know what datalogs I need to take to get the car running strong.
Thanks,
- Skylar.
Welcome you the forum Skylar,
I suggest you start with a file with mods closes to yours and adjust the file accordingly. Make sure the fueling is ok and no knock is present.
-Ed
Re: Final tune for the Si
Posted: Wed Aug 16, 2023 6:52 pm
by skymcd
Hey Ed! Thanks for the reply.
I have a calibration that runs pretty smooth, no knocks, but in WOT it runs a bit richer than what I’d like (13.5 ~ 14 AFR) whereas I’d prefer 12.5, could you help me along in adjusting it?
If not, do you vouch for any Etuners that I can hit up?
Thanks,
- Skylar.
P.S you should start that channel, this stuff is such a rabbit hole / black box magic!
Re: Final tune for the Si
Posted: Wed Aug 16, 2023 8:30 pm
by CalibratEd
skymcd wrote: Wed Aug 16, 2023 6:52 pm
Hey Ed! Thanks for the reply.
I have a calibration that runs pretty smooth, no knocks, but in WOT it runs a bit richer than what I’d like (13.5 ~ 14 AFR) whereas I’d prefer 12.5, could you help me along in adjusting it?
If not, do you vouch for any Etuners that I can hit up?
Thanks,
- Skylar.
P.S you should start that channel, this stuff is such a rabbit hole / black box magic!
Post the calibration and a datalog. I can take a look at it.
I will work on the channel once I get a decent list of videos ideas and the time to sit and record.
-Ed
Re: Final tune for the Si
Posted: Wed Aug 16, 2023 10:05 pm
by skymcd
Alright here is the calibration and datalog. I did a third gear 2000 - 8600 RPM WOT pull.
Re: Final tune for the Si
Posted: Wed Aug 16, 2023 10:32 pm
by CalibratEd
I made some minor adjustments. Load the new file and create a similar datalog.
-Ed