Hondata

Hey guys! New to the world of kpro here..
Was wondering if youbguys can help me out or not..

So I have a jdm k24a 3lobe and was wondering if some has a base map similar to my set up.. I'm about to swap my motor in and I just uploaded the k24 map (in other) but the map is not even close to what I have, would that still be okay?

So for parts list I have.

K24a
Kpro V4
Rbc intake manifold
Hybrid - fuel rail
Rsx type s - oil pump
Rsx type s - 50° VTC
PLM K24 - headers
Exedy - Stage 1 Clutch
Rdx fuel injectors - 410cc
Stock ep3 Throttle Body
2.5 header back
Rsx type S Tranny

If anyone can help me out that would be amazing..
Thanks in advance!!

Hi, most important is to have the right injectors registred in your calibration under Fuel Injectors for a good start up and then you will have to add fuel using your lambda sensor to the fuel maps to accomodate your mods!!

Okay awesome! Thank you for your help!.
And all this can be done on the kpro right?!

K-Pro is fully tunable. This will need to be properly tuned on the dyno.

Okay awesome!
yeah i just wanna load a map as close to my setup, so i can drive it to get tuned.

if its just to get to the dyno dont worry load a map for k24 - fuel injectors > 410cc and choose rdx dead times, you can also calibrate your tps if you want under Throttle. And drive soft there to be safe

Thank you so much!! You guys are awesome for your help!.

Laoboy85 wrote: Tue Apr 25, 2023 11:40 am Thank you so much!! You guys are awesome for your help!.

You can also contact your tuner and see if they can provide you a basemap to get you to the dyno.


-Ed

Thanks guys!!