Hondata

Just out of curiosity why on your Hondata FL5 91 and 93 flash tunes you don't use the air charge limit table and on the FK8 tunes you use it?

Another thing that I saw is that on the factory FL5 calibration the general torque limit table have some lower values compared to the request torque tables, I can't understand why is programmed this way.

Thanks in advance

We just used a different air charge limit table. 'Turbo max air charge' vs 'Air charge limit'.

The second question you would have to ask Honda/Bosch.

Hondata wrote: Thu Apr 20, 2023 3:50 pm We just used a different air charge limit table. 'Turbo max air charge' vs 'Air charge limit'.

The second question you would have to ask Honda/Bosch.

Could you please show me this table

I understand your point, Honda/Bosch have some logic on this point that I don't understand.

Thanks

Tables, 'Turbo Max Air Charge (IAT)'

Hondata when I load the 93 tune just as it is, a couple of us owners are getting an overboost code. Do you have a solution to that?

What version of software have you used to upload? Did you read the release notes for FlashProManager 4.0.9?

I am currently using 4.0.9 and I get these codes currently. RV6 DP drop in filter and non res exhaust

Ok, more specifically then - what is the minimum map pressure set to in your calibration?

Hi,
I'm having the same issue with P0234. I downloaded my the manager on 4.20.23. What are the steps/procedures to adjust the tune to eliminate the DTC? I currently have a Milltek exhaust and front pipe and drop in filter (not sure if that affects anything). I have a CTR FL5.

Thanks

From Help, About, what is the version of software you are using?

Current version V4.0.9.0 2023-04-19 (715 MB)

It is to do with the rev hang. If the throttle is released from redline then the manifold pressure falls much faster than the ECU expects, and the ECU reports this as an overboost condition.

So either disable P0234 or un-select the rev hang mod or wait until later tonight for another release.

Please see info at: viewtopic.php?p=131237#p131237

Thank you I disabled the p0234 after the update. Now to patiently wait for everything to be open so I can put the P700 in

How do you disable the DTC. newbie here.