Wideband Not Showing Voltage

[Sw20KFrank]

Hey all perhaps someone can help me ive got a k24/k20 swapped mr2 and i am using an aem 30-4110 wideband and cannot see voltage in Kmanager even though when i probe the while line from the wideband i can see voltage between 2-4v however k manager shows only 10.0afr no voltage i have the white wire connected into analog 0 and fully activated in k manager but vehicle just sticks pig rich and shows no voltage and does indeed run rich

[Spunkster]

Post your calibration and a datalog showing the issue.