Page 1 of 2
Flashing red light
Posted: Tue Feb 14, 2023 1:26 pm
by Shneaky
So I recently had someone install my Hondata, and when I go to connect my ecu to the laptop d2 flashes red while d4 stays green.
I tried data logging and it reads nothing. I’m guessing connection isn’t right because I can’t even upload anything.
Re: Flashing red light
Posted: Tue Feb 14, 2023 1:52 pm
by Spunkster
What is the serial number that is on the s300 board inside the ECU?
From Help, About, what is the version of software you are using?
Is J12 cut on the ECU?
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:00 pm
by Shneaky
Serial: 62553
I’m running version 2.8.1.0
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:00 pm
by Shneaky
And no j12 is not cut
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:01 pm
by Spunkster
Is J12 cut on the ECU?
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:02 pm
by Shneaky
No
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:15 pm
by Spunkster
It must be cut.
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:16 pm
by Shneaky
So there shouldn’t be a j12?
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:29 pm
by Spunkster
removed or one leg cut and lifted away from the board
Re: Flashing red light
Posted: Tue Feb 14, 2023 2:57 pm
by Shneaky
Still flashes red
Re: Flashing red light
Posted: Tue Feb 14, 2023 3:03 pm
by Shneaky
And nothing reads for datalogging
Re: Flashing red light
Posted: Tue Feb 14, 2023 3:28 pm
by Spunkster
Are you able to upload?
Did the person that install it test the ECU after socketing it?
Re: Flashing red light
Posted: Tue Feb 14, 2023 3:33 pm
by Shneaky
Would it light red for a second and then start flashing again if it uploads??
Re: Flashing red light
Posted: Tue Feb 14, 2023 4:35 pm
by Spunkster
What happens when you try to upload a calibration?
Re: Flashing red light
Posted: Tue Feb 14, 2023 4:38 pm
by Shneaky
The red light would stay on for about a second or 2 and then start flashing