Hondata

Was driving today and out of the blue the ecu bricked itself. Car was fine for months nothing new. Was driving and the check engine light came on so I tried to connect with my phone to check and clear the code but it never connected, so I grabbed my laptop and it still wouldn’t connect, I re download and installed kpro and still no luck. Car is stuck in limp mode and has a firm 4k rev limiter

2004 rsx k24a2
Ep3 engine harness and ecu
37820-PNF-A11
098213-3813
61305

From Help, About, what is the version of software you are using?

Most current release

What is the actual version number?

4.5.4.0

With the ignition in the on position and everything plugged in, what does it show in the lower left corner?

Drivers installed and off line

Purchase date of 03/31/22

Have you checked the fuses and wiring in the vehicle?

Have you opened the ECU and looked for any signs of damage?

I know that e9 has power and e7 is grounded. I put my ecu in a know good car and it still didn’t connect then plugged my friends ecu back in his car and his car fired up. I did open for inspection nothing looks burn or smell burn.

Send and email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

Include a link to this thread.

i’m having the same problem. all was working fine until today. got an ep3 and the car is stuck in limp mode and won’t go past 3k. it’s running heavily rich and tried plugging the laptop into the ecu and i get error at the left hand bottom of my screen. has anyone got any suggestions of why it’s doing this?

Please start you own thread and include complete details.

where would i make that? sorry new to the forums

click the new topic button