Page 1 of 1

K24a Basemap

Posted: Fri Dec 16, 2022 9:37 pm
by grahamb16
I have a K24A swapped 07 Civic Si. I have swapped over all of the necessary OEM parts from the old engine and installed the RBC Intake Manifold as well as the 50° VTC. I have the 8th gen Racing Hondata and want to get it tuned for daily driving

Re: K24a Basemap

Posted: Fri Dec 16, 2022 10:44 pm
by CalibratEd
Graham,

Per our pm. You are unable to load the Tsx calibration as it is not allowed by Hondata. You are going to have to get a custom tune for your setup utilizing the 8th civic calibration file as a base.

-Ed

Re: K24a Basemap

Posted: Sat Dec 17, 2022 11:51 am
by grahamb16
I found one off another thread and have been using it. Here is a datalog from my last drive.

Re: K24a Basemap

Posted: Mon Dec 19, 2022 1:58 pm
by CalibratEd
grahamb16 wrote: Sat Dec 17, 2022 11:51 am I found one off another thread and have been using it. Here is a datalog from my last drive.
Graham,

You need to post the calibration file you are running.

-Ed

Re: K24a Basemap

Posted: Mon Dec 19, 2022 9:09 pm
by grahamb16
Here ya go

Re: K24a Basemap

Posted: Wed Dec 28, 2022 5:58 pm
by Pacalocks
Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?

CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.

Re: K24a Basemap

Posted: Wed Dec 28, 2022 6:14 pm
by CalibratEd
Pacalocks wrote: Wed Dec 28, 2022 5:58 pm Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?

CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
Pacalocks,

Sure send me a PM

-Ed

Re: K24a Basemap

Posted: Wed Dec 28, 2022 6:15 pm
by CalibratEd
grahamb16 wrote: Mon Dec 19, 2022 9:09 pmHere ya go
Graham,

I will take a look at the file when I can.

-Ed

Re: K24a Basemap

Posted: Thu Dec 29, 2022 5:04 pm
by grahamb16
Pacalocks wrote: Wed Dec 28, 2022 5:58 pm Graham, I was wondering if you are running an aftermarket I/H/E on your engine? Also, does the car run ok for daily driving on the file you posted?

CalibratEd, I was trying to PM you to pick your brain on something, if you had the time.
Pacalocks,
I swapped the stock intake with the RBC Intake from the k20. Headers and exhaust are still the same, also the 50° VTC from the k20 was installed as well. As far as daily driving, it's been doing well. I haven't had any issues so far

Re: K24a Basemap

Posted: Thu Dec 29, 2022 5:04 pm
by grahamb16
CalibratEd wrote: Wed Dec 28, 2022 6:15 pm
grahamb16 wrote: Mon Dec 19, 2022 9:09 pmHere ya go
Graham,

I will take a look at the file when I can.

-Ed

No worries mane

Re: K24a Basemap

Posted: Thu Dec 29, 2022 8:36 pm
by CalibratEd
grahamb16 wrote: Thu Dec 29, 2022 5:04 pm
CalibratEd wrote: Wed Dec 28, 2022 6:15 pm
grahamb16 wrote: Mon Dec 19, 2022 9:09 pmHere ya go
Graham,

I will take a look at the file when I can.

-Ed

No worries mane
Graham,

I need a longer datalog. I can not do much with 3 seconds lol

-Ed

Re: K24a Basemap

Posted: Sat Dec 31, 2022 10:34 am
by grahamb16
Sorry about that, this one should be long enough

Re: K24a Basemap

Posted: Wed Jan 25, 2023 11:34 am
by grahamb16
CalibratEd wrote: Thu Dec 29, 2022 8:36 pm
grahamb16 wrote: Thu Dec 29, 2022 5:04 pm
CalibratEd wrote: Wed Dec 28, 2022 6:15 pm

Graham,

I will take a look at the file when I can.

-Ed

No worries mane
Graham,

I need a longer datalog. I can not do much with 3 seconds lol

-Ed
Have you had a chance to look at this yet?

Re: K24a Basemap

Posted: Wed Feb 08, 2023 8:05 pm
by CalibratEd
I would be careful. The car is running very lean. I increased the fuel.

-Ed