kpro not connecting to laptop or bluetooth. no green or red light
Posted: Fri Oct 21, 2022 6:08 am
My kpro v4 was running just fine for the past year. Its dyno tuned e85 etc. I recently drove the car for about an hour. Parked it for about an hour then I decided to go back out. When I started it back up, the car idled rough. Looks like it was leaning out on the AFR. Then it stalled out. I tried to start it again and same thing, idle for couple seconds the stalls out. Oil press, fuel press, and voltage is fine from my gauges. When it does idle, i did notice that the check light popped on. I tried to pull the codes from the app and i couldnt connect anymore. So I tried to connect to the laptop and theres no lightning bolt. Cant go to tools and and download the map either. At the bottom left corner, it says "driver intalled" and "offline" when the usb is connected and the engine harness. I dont see a red or green light. The serial number is 60720 and im on a PPA ecu.
The only recent wiring did was add AC to my swap. I went into kpro to switch the oil pressure switch to activate the ac. This was 2 days before I started having issues. I checked the main relay already by pulling it and testing the relay. Made sure the relay clicked like its suppose to do. Also checked every fuse under the dash. Not sure what else to check.
The only recent wiring did was add AC to my swap. I went into kpro to switch the oil pressure switch to activate the ac. This was 2 days before I started having issues. I checked the main relay already by pulling it and testing the relay. Made sure the relay clicked like its suppose to do. Also checked every fuse under the dash. Not sure what else to check.