2013 Civic Si need help with basemap tune
Posted: Wed Oct 12, 2022 5:23 am
Good morning, I have recently done a few mods to my Si finally. I’ve ordered the flashpro in which it should arrive today. I’m needing some help on what exactly to do to try to get it running to be able to drive properly until I can get it to a dyno tuner. So far I have done the
RBC Swap
Acuity Cold Air Intake
RV6 Catted exhaust
Invidia Q300 exhaust
Acuity Fuel rail
Stock injectors with adaptors
Haasport Rear Motor Mount
Acuity Short Throw Shifter
Not sure if the bottom two mods mean much if anything but just figured I’d throw them in there. Any help on where to start or what would be recommended would be greatly appreciated.
RBC Swap
Acuity Cold Air Intake
RV6 Catted exhaust
Invidia Q300 exhaust
Acuity Fuel rail
Stock injectors with adaptors
Haasport Rear Motor Mount
Acuity Short Throw Shifter
Not sure if the bottom two mods mean much if anything but just figured I’d throw them in there. Any help on where to start or what would be recommended would be greatly appreciated.