Hondata

Hey guys so I’m running into a problem with my k24 swapped Acura rsx the car is an 03 base has a couple type s parts in the swap as well. Anyways my speedo on the cluster works completely fine it shows my speeds accurately but when I open up hondata my speed reads 0 as I’m moving and once I start going faster it goes up to 3 km/h and it just stays there. Is this something I can change in my k pro or am I looking at needing to get a new speedo or a frequency converter let me know thanks 🙏🏽

-broken dc5

I’m going for a dyno soon by someone who specializes in k pro so if it can be done through the k pro itself then I should not have issues but he doesn’t offer refunds so I don’t wanna get there to find out it was the speed sensor itself and then I can’t even dyno it

Post the calibration and a datalog showing the issue.