Page 1 of 1
Stock K24A1 with K20A2 HEAD
Posted: Wed Jul 27, 2022 4:11 pm
by ryanmaclennan
Hey looking to see if anyone would have a calibration I could run
K24a1 ( CRV ) stock bottom end 9.6-1
k20a2 head
PRB intake manifold
Type s oil pump
Full intake / 3” inch exhaust
K20a2 injectors (310cc)
Thanks !
Re: Stock K24A1 with K20A2 HEAD
Posted: Wed Aug 03, 2022 2:19 pm
by CalibratEd
ryanmaclennan wrote: Wed Jul 27, 2022 4:11 pm
Hey looking to see if anyone would have a calibration I could run
K24a1 ( CRV ) stock bottom end 9.6-1
k20a2 head
PRB intake manifold
Type s oil pump
Full intake / 3” inch exhaust
K20a2 injectors (310cc)
Thanks !
I can help you out. Can you provide datalogs with wideband data?
-Ed
Re: Stock K24A1 with K20A2 HEAD
Posted: Sun Aug 07, 2022 7:13 am
by ryanmaclennan
hey ed , i never logged with kpro before i have with ecutek though sure i can figure it out ! I uploaded the the K24A2 ( 50 degree vtec ) tune from kpro under Type S calibrations , i dont have a wideband atm im running Disabled ( open loop ) with no WOT comp . Im going to order a wideband soon so i can e tune !
Re: Stock K24A1 with K20A2 HEAD
Posted: Sun Aug 07, 2022 8:13 pm
by CalibratEd
ryanmaclennan wrote: Sun Aug 07, 2022 7:13 am
hey ed , i never logged with kpro before i have with ecutek though sure i can figure it out ! I uploaded the the K24A2 ( 50 degree vtec ) tune from kpro under Type S calibrations , i dont have a wideband atm im running Disabled ( open loop ) with no WOT comp . Im going to order a wideband soon so i can e tune !
Sounds good. Reach out once you have a wideband connected. I can provide you an etune if you don’t already have a tuner.
-Ed