Hondata

Hello,

I have 2 s2000 with flash pro. Both are AP2 with drive by wire. On my second one, I bought the car with flash pro already I stalled as it was already boosted. I unfortunately had to rebuild the motor which is fine.

My issue is I can’t connect to the flash pro module anymore. I have a new turbo and injector but can’t click on anything in the manager on that car.

What can I do?

Also, any news on offering EBC again?

What is the serial umber that is on the FlashPro?

From Help, About, what is the version of software you are using?

Hello,
My serial number is FP-S2K-US-31825 and i'm on flashpro manager version is 3.9.5.0 build 2689.

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.

Hello,

Under the help menu, "Send feedback to Hondata" is grayed out and I can't select it. The key position is "On". The flashpro does blink green when the car is connected to it and also does flash green when I connect my computer to it.

I did verify that the computer works by connecting it to my other car. Is there any way to hard reset the device? I don't care about the tune stored in it as the car needs to be re-tuned as I've changed the turbo, injectors, and valvetrain.

With the USB plugged in what shows up in the lower left corner of the software?

I made a quick video below

https://youtu.be/-C_A38jkhaY

Whether I plug flash pro:
1. USB only
2. OBD2 only
3. Both USB and OBD2
The same green status light is flashing.

Send and email so support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

Include a link to this thread.

Sounds good. Thank you for the help. Will keep the forum updated in case someone else has the same issue.

Cheers!