Page 1 of 1
tune for completely fully bolt on 8th gen si
Posted: Sun Jun 12, 2022 6:36 am
by sammy
3.5in cai skunk2, skunk 2 72mm tb, skunk 2 pro series intake manifold, skunk 2 headers/exhaust and 410 injectors
Re: tune for completely fully bolt on 8th gen si
Posted: Sun Jun 12, 2022 9:45 am
by EFICU
Are you running RDX 410's? If so, where were they purchased from?
Re: tune for completely fully bolt on 8th gen si
Posted: Sun Jun 12, 2022 9:47 am
by sammy
Yes they are rdxs not sure bought the car all done up
Re: tune for completely fully bolt on 8th gen si
Posted: Sun Jun 12, 2022 9:49 am
by sammy
ive tried basemaps on hondata and when i cross over my afr spikes to 15-17 but before its at 11-12 cruising its at 14.5-14.7
Re: tune for completely fully bolt on 8th gen si
Posted: Mon Jun 13, 2022 8:39 pm
by EFICU
Yeah my concern is the validity of the RDXs. If they are fake it will be impossible to tune it. I can start you on a basemap and see how it looks just to determine the injectors performance. From my recent experience with some fake ones I can probably tell pretty quick. Then we can decide how to tune it from there.
Re: tune for completely fully bolt on 8th gen si
Posted: Tue Jun 14, 2022 1:51 pm
by sammy
I highly doubt they are fake car made close to 230whp on a setup with a 2.5in semi hot intake, car used to drive perfectly lost the tune and i also just found two of my coil packs had no bolts so i took everything out and cleaned it all. but yes please send a good basemap would be extremely appreciated.