Page 1 of 1
Laptop died while uploading new calibration
Posted: Sun Jun 05, 2022 7:07 am
by Sotoc
Last night I was uploading a new calibration to my 2021 CTR when my laptop died, now the car wont start and is in a recovery mode. The Laptop doesn’t read the ECU so it’s not telling me any kind of information on whether or not it detects the recovery mode of the car. Please help
Re: Laptop died while uploading new calibration
Posted: Sun Jun 05, 2022 11:50 am
by Hondata
An upload from the FlashPro is independent from the laptop so it does not matter if the laptop is switch off or disconnected.
Unplug everything, switch off the ignition, plug everything back in and then return the ECU to stock.
Re: Laptop died while uploading new calibration
Posted: Sun Jun 05, 2022 2:31 pm
by Sotoc
Will give this a shot and keep you updated thanks!
Re: Laptop died while uploading new calibration
Posted: Sun Jun 05, 2022 6:19 pm
by Sotoc
It worked! Thank you so much appreciate it!
Re: Laptop died while uploading new calibration
Posted: Mon Jun 06, 2022 7:05 am
by Hondata
Great. Thanks for the update too.
Re: Laptop died while uploading new calibration
Posted: Mon Jul 24, 2023 5:58 pm
by CarlosL2001
Sorry to revive this post, but same thing happened to my 2022 civic, i was returning ecu to stock and my laptop died on me in the beginning and now my car is locked and I'm unable to even do anything at all. I have unplugged the flashpro and that has not worked, when I click to unlock my car it tells me that it does not recognize the vin, this flashpro has only been on this car and no other car, i bought it from hondata.
Re: Laptop died while uploading new calibration
Posted: Tue Jul 25, 2023 8:18 am
by Hondata
Did you try the instructions as given in the second post?