Hondata

I recently got the Flashpro and everything is up to date on the laptop with software and drivers. I was given a 2014 si basemap from EU but the gas in the EU is definitely a higher octane than here in the US. Since I have been running 100 octane in my us 2013 si.

I have another tune that I was given and it is supposed to be for 91/93 octane but the calibration is set to 2014-2015 si and if i select 2013 SI in the calibration section it states that it will change things with the tune or is that setting safe to change without causing any issues.

I appreciate any help because I am definitely new to this

European 2013 Civics are not supported by the software so there are calibrations available for them. I recommend using one of the built in calibrations that are found when you click on the New Calibration button.

Well the tune that I have is for the 2014-2015 si and I was going to change the calibration to a 2013 SI. Does anyone know if this would cause critical issues?

You must choose the correct vehicle type from the New Calibration window and it will give you all calibrations that can then be used.

Will the calibrations affect the tune or is it just because its a different vehicle?

If they are incompatible it will not allow you to upload.