Launch Control always working when load map into chip
Posted: Tue Apr 05, 2022 11:24 am
Hello all, greetings from Spain.
I'm trying to load an s300 calibration fully working into a chip for p28, but launch control is always on, even when i disable launch control in smanager. I tried every combination with all options, inverting output, with and without burnout rev limiter.... im going crazy.
If i set launch control under 4700, it works at the rpm set with the chip, but if i set rpm above 4700, launch control stays at 4700.
I tried to change launch control speed limit to 0 but it changes to 1...
Always using the same calibration with the s300 board which works fine and launch control do what is supposed to do.
I use <pirate software link removed> to convert .skl (smanager calibration) to .bin and moates chip burner with flash&burn by moates to write chip.
Hope you can help me, thank you very much.
I'm trying to load an s300 calibration fully working into a chip for p28, but launch control is always on, even when i disable launch control in smanager. I tried every combination with all options, inverting output, with and without burnout rev limiter.... im going crazy.
If i set launch control under 4700, it works at the rpm set with the chip, but if i set rpm above 4700, launch control stays at 4700.
I tried to change launch control speed limit to 0 but it changes to 1...
Always using the same calibration with the s300 board which works fine and launch control do what is supposed to do.
I use <pirate software link removed> to convert .skl (smanager calibration) to .bin and moates chip burner with flash&burn by moates to write chip.
Hope you can help me, thank you very much.