Hondata

Hi.

I have a ek with k20z3 turbo swap.

My speed signal have problems and is impossible that work again.

I can't use the lauch control because the signal vss always is cero.

Now I need use a switch for activate and deactivated the lauch control.


Has anyone done it, could you give me a hand? I would be very careful 🙏

The ECU will need a proper speed sensor input.

What is the ECU part number you are using?

What is the serial umber on the K-Pro board inside the ECU.

I am using a PNF ecu and kpro v4. Remember that I have one problem with the vss and is impossible that work. Because that I need alternative lauch control switch for activate

You need to determine why the speed sensor does not work and fix that.