Hondata

KManager Crashed Whilst Flashing ECU Now Car Wont Start And KManager Won't Connect, changed a couple of bits in my software calibration and got about halfway through uploading to car, the software crashed and closed, restarted the software and now my car isn't starting and my KManager won't see the ECU, when ignition is switched on the software says ignition off and error, any help appreciated please as my car is now stuck in a location it shouldn't be in.

What is the serial number that is on the K-Pro board inside the ECU?

From Help, About, what is the version of software you are using?

I was just about to post the exact same thing to the letter, Is this something that Hondata has done in the newest update ?
My car was running fine. I then went in to Kmanager and it said there was an update (because i hadn't used it since may) and installed it, made some changes to the calibration and got about halfway through uploading to car, the software crashed and closed, restarted the software and now my car isn't starting and my KManager won't see the ECU, when ignition is switched on the software says ignition off and error

There's no problem with the latest software. The questions you need to answer are in the post above yours.