Hondata

I am trying to set up ethanol 0-5v input on the ECT2 input to my ECU but I cannot find the Ethanol parameters to enable in my calibration. Where are they located?

Vehicle is 2011 CR-Z 6MT.

Thanks!

The CR-Z does not have flex fuel capability.

Hondata wrote: Mon Nov 01, 2021 8:59 am The CR-Z does not have flex fuel capability.

Ok, is this something that can be added? Flex fuel support is what lead me to choose a FlashPro because it is advertised as supporting flex fuel. The manual does not mention flex fuel not being available for CR-Z. It implies that all FlashPro vehicles support flex fuel: https://www.hondata.com/help/flashpro/i ... tuning.htm

The CR-Z product page does not mention flex fuel.

https://www.hondata.com/products/flashp ... pro-crz-us

It is not going to be added.

I am having this issue with my 07 Civic Si using Sirimoto Flex Fuel Kit for 8th gen. My flashpro has been updated to the latest version.

oinojo wrote: Wed Mar 09, 2022 11:40 pm I am having this issue with my 07 Civic Si using Sirimoto Flex Fuel Kit for 8th gen. My flashpro has been updated to the latest version.

It sounds like you're using a race calibration. The race calibrations do not have ethanol settings, you will need to use a standard calibration and then tune it for your mods. If you post the calibration we can confirm you have a race calibration or not, but I believe the only ones without ethanol settings are race calibrations.

Thank you! that was it. I was racking my brain trying to figure out why it wasn't showing.

oinojo wrote: Thu Mar 10, 2022 11:00 am Thank you! that was it. I was racking my brain trying to figure out why it wasn't showing.

You're welcome.