Hondata

Hey guys,

I have a SpeedFactory 3 Bar Map Sensor that I am installing. When I go into Smanager, does it matter which brand of "3 Bar" that I choose? I see Motec, Neetronics, & MSD. No SpeedFactory, so which do I pick?

The reason I ask is because on the SpeedFactory Data Sheet from their site it says to change:
Scalar to : 617
&
Offset: 11

But, when I change the offset it change the type of Map sensor to "custom" under the dropdown.

Is this supposed to happen??

If it's not in the dropdown and you enter custom parameters then yes, it should say custom.

Thank you!

I just wanted to make sure.

Will respond back with results. I just installed my Walboro 255.

Just an update, I installed the SpeedFactory 3 Bar Map Sensor along with my 255 Walboro.

Car started great, just had to add a small bit of fuel overall. Haven't drove on it yet but everything seems great in regards to AFR's & how it starts & idles.