Hondata

Hi

Need some guidance to get factory wideband working.

2005 Accord JDM CL7 K20A
ECU is 37820-PRC-013
Hondata info: Serial 10021, Firmware: 3.00, Software 4.4.60, ECU type: PRB - US RSX Type S

Currently there is no change in the Primary O2 current and the AF does not move.

* We have continuity traced all the O2 sensor wires / pins, they seem to be fine. Signal goes to A6, signal ground to A16 and there is heater voltage and
ground.
* We have fitted a new genuine sensor.
* Parameter menu, radio button set to "Built in wideband"

Anyone got any ideas?

Thanks

You need to try the ECU in a known working vehicle.

The K-Pro is not supported in an Accord.

Hi

Thanks for your reply. This is using an adapter loom (hence why we checked the pin continuity), and everything else works fine. As far as I can tell the O2 sensor is the correct one for the ECU. Any other ideas?

No, you need to try it in a known working vehicle.

ok thanks

Can't get a test vehicle. Can we send you this ECU? Must be some kind of plan b?

Where are you located?