Page 1 of 1
S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 9:01 am
by mboettigheimer
Hey what’s up guys. I’m trying to troubleshoot why my dash isnt reading any can data. Iv troubleshot with Aem for their dash,checked wiring, and checked I was getting 60 ohms between high and low. How do I check if the s300 itself is sending can data at all?
Re: S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 10:57 am
by Spunkster
From Help, About, what is the version of software you are using?
Re: S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 11:48 am
by mboettigheimer
It should be the latest. I installed the software not too long ago. I’ll have to check
Re: S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 11:51 am
by mboettigheimer
It is 2.7.6.0
Re: S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 12:15 pm
by Spunkster
Re: S300v3 to Aem cd7 dash
Posted: Mon Jun 28, 2021 12:36 pm
by mboettigheimer
Awesome! I’ll try that out when I get home from work!
Re: S300v3 to Aem cd7 dash
Posted: Tue Jun 29, 2021 6:38 pm
by mboettigheimer
That definitely worked. Thanks Spunkster!
Re: S300v3 to Aem cd7 dash
Posted: Wed Apr 27, 2022 6:05 pm
by mboettigheimer
Back again lol. Updated some of the analog inputs and now my aem cd7 is not receiving any info from s300. Dash was working right before I uploaded to ecu. My baud rates match up, I have the 120 ohm resistor in. I even updated to 7.8. Sometimes the dash says can2 disconnected, sometimes it says can2 recieve timeout.
Re: S300v3 to Aem cd7 dash
Posted: Thu Apr 28, 2022 3:15 am
by mboettigheimer
I figured it out. Was a configuration problem on the aem side.