Hondata

Hi
I bought a fn2r with hondata already been tuned for the mods by remote tuner in Africa

I am going to swap all the mods to another fn2r and wanted to swap over the flashpro
But stupid me as I have never used the hondata software before and accidentally pushed read protect on the laptop

So I had to delete both maps in order for it to unlock
Is there anyway of downloading the map from the cars ecu or reading it as it's still flashed in there ?

If not anyone willing to give me a basemap to suit so I can limp it to my local tuner in Australia
My mods are
Stock injectors
RBC inlet
Jtune headers
200cell cat
2.5 inch axle back
Skunk 2 cams
Skunk 2 long ram CAI which I think would throw off the maf curve
Thank you very much for any advice

No, you cannot read the file from the ECU. You will have to open open a file you have saved on the laptop/email, or start with a new calibration.

If you need help getting a basemap to drive on to the dyno let me know. We can tune it on the 0* cam angle so you can drive it without worries to the dyno. It might take a revision or two to get it good, but it's no problem. Just let me know.