Hondata

I'm trying to setup Fuel Percent Level using K-Pro V4 and AEM CD-5 Dash.

I also have a ICM Fuel Sender Unit: https://ironcanyonmotorsports.com/icm-fuel-sender/

From research here are my ohms values for Empty: 4080 and Full: 252 on an 1994 Acura Integra GS-R.

The issue is I'm getting a reading on my cluster showing 100% without the fuel plugged in and I'm not quite sure if I set the Analog0 Channel correctly.

Do I put Custom for conversion, Percent for type/unit and do I need to put anything for custom input?

How is the K-Pro communicating to the dash?

Spunkster wrote: Tue Mar 16, 2021 10:23 am How is the K-Pro communicating to the dash?

via CANH & CANL from the digital side of the K-Pro board.

Everything works perfectly from the K-Pro other than the Analog Fuel Level Channel.

I did my best and follow this install and was told that the fuel works the way they wired it (same exact way as me).

https://www.youtube.com/watch?v=_IXzn1CFKf4

If it works for them and not in your setup, then something is different.