Page 1 of 1
Aim mxs 1.2 kpro v3 issue
Posted: Fri Feb 26, 2021 3:27 pm
by Undefined4door
Hi I have a kpro v3 and aim mxs 1.2 strada, I have the aim mychron board wired to the gauge cluster and to the appropriate pins on the ecu a24 and e24. I set up the multiplexer to 9600bps and used the aim program to configure to hondata kpro ecu. I am currently not getting any data on the gauge besides voltage. Any help is appreciated!
Re: Aim mxs 1.2 kpro v3 issue
Posted: Fri Feb 26, 2021 4:04 pm
by Spunkster
Re: Aim mxs 1.2 kpro v3 issue
Posted: Fri Feb 26, 2021 5:00 pm
by Undefined4door
Hi spunkster yes I have, and have set up the multiplexer per aim instructions. 9600 bps with pin connected to e24.
Re: Aim mxs 1.2 kpro v3 issue
Posted: Fri Feb 26, 2021 5:02 pm
by Undefined4door
Is there a way to verify im getting proper output out of e24 with a voltmeter or scope?
Re: Aim mxs 1.2 kpro v3 issue
Posted: Fri Feb 26, 2021 5:51 pm
by Spunkster
You will need a logic analyzer to test that.