Hondata

Any one here had similar issues? where the ecu plugs in and laptop says online and normal, and when you try to read sensors to recal the tps and others it freezes to a certain values, and everything i reboot the k manager and do it again, it datalog freezes to the same values again. engine MIL is on and i cant check it either.

HELp

i got some video i will load up

It always stuck on these
Values whenever datalog, car starts, mil on, and loud and unload maps(i think anyway)

What is the serial number that is on the K-Pro board inside the ECU?

Tried a V1 on the same car, works fine. 🤷‍♂️

Who installed the K-Pro into this ECU?

This unit here we got it from Speedscience, New Zealand. I been doin some researching, is the PRA ecu have different ecu pin out thats causing this? any input would be great!!

thank you

What vehicle is this being used on?

This was sold as an install kit. You may want to have Speedscience take a look at the ECU as well.

Hi, this is goin on an S2000 with a K24 swap, 2NRS PNP harness etc. Got it running on the V1 currently to get other small things done. I have contacted Speedscience and it looks like might the ecu it self is the issue. The faulty V4 can upload and start car running, but cant recal or data log anything.

Thank you

regards