Page 1 of 1

Always rich on low cam on transition into positive pressure

Posted: Thu Sep 03, 2020 11:13 pm
by LstCivic
On a few different cars I cannot get it to lean out on the transition into boost. Right around 0 no matter how much fuel I pull it doesn't seem to make a difference in the log, there are no sharp jumps in pulsewidth. From column 9 it goes from 13.5 straight to 10.0 in column 10 even if I drop the whole column to lower than column 7 .

Re: Always rich on low cam on transition into positive pressure

Posted: Fri Sep 04, 2020 10:08 am
by Spunkster
Make sure you are editing the correct cam angle map, as it is probably running on a different map then you are editing.