Hondata

Hi everyone,

Set up:
Kpro V3
2000 Integra Gsr w/ k20a2 swap
Hybrid Racing Conversion Harness
RSX Type S stock harness

Made all the connections needed for everything to work from the conversion harness to the RSX Type S engine harness.

ISSUE

• [] When i plug the Kpro onto my laptop, and start 'datalogging', most sensor readings are at ZERO
  • [] and according the Kpro, no error codes (which is weird to me)
    • []For the systems under Error Codes, it also says not supported!
      
      When i try to connect my scanner to the OBD port, it tells me unsupported, like if it doesnt read it.
      
      My Integra starts up (cranks for a long time until it turns over), and revs up, cluster readings work (RPM, Tachometer, fuel).

What is the serial number that is on the K-Pro board inside the ECU?

From Help, About, what is the version of software you are using?

Serial Number - Kpro 13175
Software - v4.4.4.0

When was the last time that this was working?

Have you tried the ECU in a known working vehicle?

Spunkster wrote: Thu Sep 03, 2020 9:06 am When was the last time that this was working?

Have you tried the ECU in a known working vehicle?

The K20a2 and the Hondata Kpro v3 we're taken both off a 2002 Acura RSX Type S. I drove the RSX for a couple of months no problem. Which is why I dont know why its not reading any sensors

the K20a2 + Hondata kpro is the swap set up i am using on my DC2 Integra

Have you uploaded a calibration to the ECU since updating the software?

Spunkster wrote: Tue Sep 22, 2020 11:37 am Have you uploaded a calibration to the ECU since updating the software?

Yes, I have. But I cant tell if it works since no sensor data appears when 'datalogging'

IF you set an artificial rev limit of 2000 rpm, and upload the calibration, is there a rev limit at that RPM?

Just tried this tune attached, and rev'd it (expecting to limit at 2k rpm) but it went past it

and this is what I see

It shows that it is online, but the ignition is off. You should try this ECU on a different vehicle and see if it shows that the ignition is on.

Spunkster wrote: Mon Sep 28, 2020 9:21 am It shows that it is online, but the ignition is off. You should try this ECU on a different vehicle and see if it shows that the ignition is on.

This is what it says when the car is actually on

And for some reason, once turning off the car, I heard the ECU beep twice (1 min in between each beep) .

Not sure if thats a concern or not

Is this in a different vehicle?

Spunkster wrote: Mon Sep 28, 2020 1:04 pm Is this in a different vehicle?

Same vehicle