Page 1 of 2
my calibration
Posted: Tue Aug 04, 2020 3:49 pm
by tcr1
i have install a exhaust and i would like to know if all is correct.
test#1.fpdl
Re: my calibration
Posted: Wed Aug 05, 2020 10:26 am
by Hondata
The knock control is low which is good.
But the fuel trims are quite negative. Do you have an intake?
Re: my calibration
Posted: Wed Aug 05, 2020 12:21 pm
by tcr1
Yes I have a PRL Short Ram intake Race , with the exhaust I have less torque .
I will post another recording .
+ 6 PSI
20200805_152024.jpg
Thanks
Re: my calibration
Posted: Wed Aug 05, 2020 1:27 pm
by tcr1
I made another recording .
effectively ,the accelerator to the floor and I release slowly and I feel more power.
Do you want to see the data at + 9 PSI.
test#2.fpdl
Re: my calibration
Posted: Wed Aug 05, 2020 4:16 pm
by tcr1
I made a recording : base map civic si 2020 and + 9 psi .
You will see the differences VS + 6 psi .
base map-si.2020.fpdl
+9 psi.fpdl
thanks
Re: my calibration
Posted: Wed Aug 05, 2020 4:23 pm
by Hondata
Your fuel trims are averaging -10%. You need to tune the AFM table because the intake has a different air flow past the AFM than stock.
Re: my calibration
Posted: Wed Aug 05, 2020 5:09 pm
by tcr1
is this on all calibrations i have posted ?
how i do that ?
Re: my calibration
Posted: Wed Aug 05, 2020 5:37 pm
by tcr1
by selecting AMF calibration for PRL cold air intake is not enough .
is there anyone doing it online ?
Re: my calibration
Posted: Thu Aug 06, 2020 7:58 am
by Hondata
What intake are you using - in one place you say SRI and another CAI?
What MAF housing are you using - street or race?
What calibration are you using?
Re: my calibration
Posted: Thu Aug 06, 2020 9:02 am
by tcr1
SRI
Race
+ 9 psi via sport button and FTS
this morning I activated the o2 sensor, to see if the motor would compensate.
test + 9 psi seulement sport.fpdl
Re: my calibration
Posted: Thu Aug 06, 2020 5:16 pm
by tcr1
I had forgotten , Invidia Catted exhaust .
Thanks
Re: my calibration
Posted: Fri Aug 07, 2020 10:20 am
by Hondata
You're using a race AFM housing but the calibration you're using is for a AFM that reads the same as stock. That is the problem.
Re: my calibration
Posted: Fri Aug 07, 2020 3:45 pm
by tcr1
which one should I choose
Re: my calibration
Posted: Fri Aug 07, 2020 4:37 pm
by tcr1
I put the stock back and I send you the data
Re: my calibration
Posted: Fri Aug 07, 2020 6:46 pm
by tcr1
intake stock
exhaust catted
+ 9 psi FTP mode sports
intake stock + 9 psi mmode sport FTP.fpdl