Page 1 of 1
Aim MXS 1.2 Strada Dash
Posted: Thu Jun 18, 2020 5:31 pm
by jgadell
The install is extremely simple yet my AIM MXS gets 0 readings, is there a way I can test that my green 232TX wire from the S300 is outputting data?
Re: Aim MXS 1.2 Strada Dash
Posted: Fri Jun 19, 2020 11:07 am
by Spunkster
Have you tried swapping RX and TX?
Are you sure the MXL and MXS use the same protocol?
Re: Aim MXS 1.2 Strada Dash
Posted: Fri Jun 19, 2020 1:38 pm
by jgadell
I have not tried swapping the RX/TX in fear to maybe fry something. I can try the TX out of the S300 to the Aim's TX and see if maybe they messed up and vice versa. Apparently, they share the same protocol. I've seen some folks running the Strada dashes on Kpro's and S300's
Re: Aim MXS 1.2 Strada Dash
Posted: Sat Jun 20, 2020 7:57 pm
by jgadell
Works, connected TX to TX versus TX to RX
Re: Aim MXS 1.2 Strada Dash
Posted: Sun Jun 21, 2020 8:15 pm
by DaX
Good to know. I've been eyeing the MXS 1.2 Strada.
Re: Aim MXS 1.2 Strada Dash
Posted: Mon Jun 22, 2020 11:44 am
by Hondata
TX and RX are always named from the viewpoint of the device. eg the S300 TX is the serial transmit from the S300. The MXS TX is the serial transmit from the AiM, so you need to connect TX to RX not TX to TX.