Hondata

Burnt fb4 and u4 everything works except laptop connects untill it says unrecognizable USB . On the ecu end I only get a red light no green I can start and drive car . Just need to know what the ferrit to buy is and the chip or black box type thing that has 3 going in and 2 going out on other side . See attached photo

I'm sorry, but we do not give out component info. If it has burned the whole board will have to be replaced. You will have to upgrade to the version 4 as the version 3 is no longer offered.

I have kpro v3 can I get an upgrade and how do I get this all too you do I need to fill something out I wanna just upgrade then to v4 thanks

The form can be found at: https://www.hondata.com/downloads/kpro4 ... e_form.pdf

Keep in mind the ECU may be damaged as well.