Hondata

Posted: **Wed May 06, 2020 11:49 pm**

From the picture attached, you can see I can't seem to attach my FlashPRO with my ECU.
Yes - My ECU is new.
Yes - I have successfully applied Jail break

My question is, do you guys already have this file or do I need to send it, as I didn't want to sit in my car for over 120 minutes, as it suggested and it be all for nothing.

Lastly I GRAVELY need this as I am on a limited time schedule to finalize a tune via a contract deadline. Please help and thanks in advance.

Posted: **Thu May 07, 2020 7:42 am**

That ECU is supported in the 3.5.8.0 release, which was just released today.

Posted: **Thu May 07, 2020 9:25 am**

Ok, thanks...How ever I should have you know that I was ABLE TO MARRY THE ECU With the FLASHPRO BUT there was an error during, at start of, flashing which was "HFPF Not enabled on flashpro". THoughts?

Posted: **Thu May 07, 2020 9:37 am**

HPFP* Is probably High pressure Fuel pump right?

Posted: **Thu May 07, 2020 10:09 am**

What calibration are you using?

Posted: **Thu May 07, 2020 10:21 am**

A make shift/in the process of trying to get data to complete in future from Derek Robinson called "Rampage Rev.01" for a turbo swap from Rampage Fab. RS-450

Posted: **Thu May 07, 2020 10:25 am**

Open 'Mods' and check 'Stock fuel pump'

Hondata

ERROR: "Cannot Lock to this ECU because ECU contains an.."

ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."

Re: ERROR: "Cannot Lock to this ECU because ECU contains an.."