Hondata

Hi,

I just received the flashpro adapter from dealer and update the flashpro version to 30.04.2020, 3.570, Built 1521.

1.
I open calibration CivicR-2015-1.fpcal and try to upload to flashpro dadapter.
But I cant do this, because I receive mismatching vehicle typ MsgBox, see enclosed pi flashpro.jpg.

2.
Another question is, I can see only to basic maps for the FK2 Europe!?!
Where are the maps for stage 1, 2, 3 or mod exhaust xyz, octan 91/95/98 and so on stored?

Thx in Advance
Frank

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.

There are not as many base calibrations for the FK2.

Have you plugged this FlashPro into your FK2 yet?

Hi,
Going online with ECU, Jailbreak was done fine in just 5 Minutes.
Upload CivicR-2015-2.fpcal with mod 2+3 (Increase TC boost/pressure ratio limit)

Result was really very good! :)
I cant verify how much higher the HP/Torque is.
But I think it is a lot!

I wonder that I saw 1,9bar TC boost.
Is that normal?

Regards
Frank

1.8 bar peak boost would be typical.

Thx, I will check this with enable datalogging

Dear Sir

Original turbo parts can upload CivicR-2015-2.fpcal to ECU?
The pressure will be increase to 1.8bar?
i was change intake, inter cooler, oil cooler, radiator & exhaust pipe, Overall condition still stable?
Thank you sir.

Best Regards
Hondata User

have you tried it?

Haven't tried yet， sir

You will have to try it.