Hondata

I am trying to enable Close Loop with narrow band O2. It read solid 4.1V all the time.
Readiness code for O2 Sensor is Supported, Not Complete.
AEM UEGO connected to ELD is reading around 2.7V at idling (data logging).

Questions:
1. Do I have a faulty narrow band O2?

I want to use closed loop for future ITB setup.
2. Should I replace narrow band? What is the recommended narrow band O2? or
3. Should I upgrade Kpro Rev.3 to Rev.4 and use wide band (AEM UEGO) for closed loop?

Set up:
S2000 2001
K-Pro v3

Thanks!

Post your calibration as well as a datalog showing the issue.

Please find attached files.

Is there any suggestions? Thank you