Page 1 of 1
Cl9 2003 immo a71
Posted: Sun May 03, 2020 8:43 am
by Schwx
It is possible to link the immobilizer of an ECU a71 without going to a workshop?
There's something to keep in mind when using an automatic ecu a71 in a manual vehicle as far as the immo is concerned?
Thanke you
Re: Cl9 2003 immo a71
Posted: Mon May 04, 2020 12:55 pm
by Spunkster
No, only an Acura dealer will be able to match the key and immobilizer.
Re: Cl9 2003 immo a71
Posted: Fri May 22, 2020 12:39 am
by Schwx
Spunkster
one question, it's normal that if I not pairing ecu in honda dealer, I will have problem with pairing flashpro with my ecu?
I pairing my ecu tsx with my car with oder diagnostic tool and working in the car without any problem but... Not pairing with flashpro.
Thanke you
Re: Cl9 2003 immo a71
Posted: Fri May 22, 2020 11:51 am
by Spunkster
Has the CAN adapter harness been installed correctly?
Re: Cl9 2003 immo a71
Posted: Fri May 22, 2020 12:56 pm
by Schwx
IMG_20200522_205632.jpg
Yes
I can see that the ecu it's connected and the Vin number it's detected but the vehicle family and model its unknown
Re: Cl9 2003 immo a71
Posted: Fri May 22, 2020 1:08 pm
by Spunkster
With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.
Re: Cl9 2003 immo a71
Posted: Mon May 25, 2020 9:56 am
by Schwx
information has just been sent to Hondata support as requested.
Re: Cl9 2003 immo a71
Posted: Tue May 26, 2020 9:52 am
by Hondata
The FlashPro is communicating with the ECU but the ECU's EEPROM information is corrupt. It could be from cloning the ECU or reprogramming the immobilizer or programming the VIN or the ECU itself could be damaged.
Re: Cl9 2003 immo a71
Posted: Tue May 26, 2020 3:03 pm
by Spunkster
This is also being used in a vehicle that is not supported or designed to work with this.