Page 1 of 1
S300 v3 issues
Posted: Sat Apr 25, 2020 5:21 pm
by PVCKZ
I have the lastest software 2.7.5.0
Car is a 96 Civic with lsvtec obd2 harness jumped to obd1 p28 ecu. Can't get information like sensors cel from car to smanager. Fuel pump primes every 5 seconds cel on and it won't read with the jumper on blue plug or obd2 scanner. Car runs at 9:1 afr idle and revs up to 4000 then cuts out and pops.
Re: S300 v3 issues
Posted: Sun Apr 26, 2020 2:53 am
by PVCKZ
PVCKZ wrote: Sat Apr 25, 2020 5:21 pm
I have the lastest software 2.7.5.0
Car is a 96 Civic with lsvtec obd2 harness jumped to obd1 p28 ecu. Can't get information like sensors cel from car to smanager. Fuel pump primes every 5 seconds cel on and it won't read with the jumper on blue plug or obd2 scanner. Car runs at 9:1 afr idle and revs up to 4000 then cuts out and pops.
Serial number on the board is 50637
Re: S300 v3 issues
Posted: Mon Apr 27, 2020 11:11 am
by Spunkster
Who socketed the ECU? Have the capacitors been replaced? Is J12 cut?
Re: S300 v3 issues
Posted: Wed Apr 29, 2020 6:24 pm
by PVCKZ
I had my boss who does micro processers as a living socket the board. No burns or excess flux anywhere. J12 is cut as well. I've since noticed that one of the four female connecters on the hondata board was missing. Contacted hondata and was told they are not doing repairs at this time
Re: S300 v3 issues
Posted: Wed Apr 29, 2020 7:07 pm
by Spunkster
If you have been in contact with us via email, then please do not continue to post here as it is twice the work for us and the answer will not change.