Hondata

Hi this error code keeps popping up even if I checked off remove error code p0101 and p0103. I cleaned my MAF sensor and checked intake and everything. I’m running 91 octane Full race Bolt ons basemap. I noticed this error code pops up when I don’t choose the intake option for AFM to read the same as stock. Is this the cause why this error code pops up? Has popped up on me 3 separate times already


2018 Honda Civic Type R

My mods are

PRL FMIC
K&N drop in filter
3” FP
3” Exhaust
Hondata Flashpro

Why are you using a full race calibration when you do not have the parts needed for that calibration?

Do you have a Full Race intake?

I know I probably shouldn’t be running this calibration. I tried the 91 octane with IC and DP with improved throttle response. My car just feels sluggish running that preset tune. I just purchased the PRL HVI stage 2 intake system and it’s on the way.

We’re you able to fix the problem? I’m dealing with the same issue

Me too. Im removing the p0101 and p0103 correction mod right now. I have the hondata maf so im hoping i keep getting this code because i dont need the mod.

What is your st and lt fuel trim reading? Mine was st -8-10 and lt around -15-18. Flash is done and its reading 0 on both but im assuming the ecm is now learning the mixture.