Base MODS - FK8 - South Africa

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
CarloT
Posts: 10
Joined: Fri Jan 31, 2020 1:12 pm

Base MODS - FK8 - South Africa

Post by CarloT »

Hello everyone.

I just would like to get my base tune/mods setup as I have had way to many differences being told as to what to do.
I am based in South Africa and our fuel here is 95 Octane with apparently no ethanol.
The only mods I have is the Takeda Momentum Cold Air Intake System w/Pro 5R Filter Media and ofcourse Hondata - everything else is stock.
So below was the tune I created and then I took it in for Dyno which i did get some really good gains.
I have now heard and been told that's its not a good to enable full power on 1dt and 2nd as this does increase knock and I must admit it does.
Until i get all my mods right now I just want a decent setup - nothing to really over stress the engine.
Your thoughts as to what mods to enable?
You do not have the required permissions to view the files attached to this post.
Post Reply