Page 1 of 1
Vtec On non-vtec HONDATA ecu
Posted: Mon Jan 13, 2020 2:11 am
by lozano232323
Soo Im building a d16y7 with a z6 head swap and a non vtec obd1 converted harness and I’m trying to figure out how run Vtec with the non-vtec hondata. There’s a option to do that with the S300 but it doesn’t really explain how
Re: Vtec On non-vtec HONDATA ecu
Posted: Mon Jan 13, 2020 8:33 am
by MikhailBjornson
Scroll down a little bit and it gives u a diagram on how to wire the solenoid if using a non vtec ecu.
https://www.hondata.com/help/smanager/i ... l?vtec.htm
If you can so some soldering and are comfortable with messing with your ecu then depending on the ecu you can actually convert your ecu to run vtec.
Re: Vtec On non-vtec HONDATA ecu
Posted: Mon Jan 13, 2020 4:02 pm
by lozano232323
MikhailBjornson wrote: Mon Jan 13, 2020 8:33 am
Scroll down a little bit and it gives u a diagram on how to wire the solenoid if using a non vtec ecu.
https://www.hondata.com/help/smanager/i ... l?vtec.htm
If you can so some soldering and are comfortable with messing with your ecu then depending on the ecu you can actually convert your ecu to run vtec.
Soo i would use one of the relays from the fuse box that’s in the engine bay?
Re: Vtec On non-vtec HONDATA ecu
Posted: Mon Jan 13, 2020 5:45 pm
by Spunkster
No, you must use a separate relay that you supply.