Page 1 of 1
Cut signal for flat shift
Posted: Fri Dec 27, 2019 10:39 am
by Paulwalsh2252900
Hi, I have a cut signal which is (pulled up to 5v,pulls to ground for duration of cut) was wondering if E16 or E29 can take the 5v ?
Thanks
Re: Cut signal for flat shift
Posted: Tue Dec 31, 2019 7:09 am
by Hondata
Yes, 5V or 12V will not harm those inputs. I would check that 5V is enough to switch off the input though.
Re: Cut signal for flat shift
Posted: Sun Jan 05, 2020 2:34 pm
by Paulwalsh2252900
Hi thanks it seems to be working just fine.
Re: Cut signal for flat shift
Posted: Tue Jan 28, 2025 5:52 pm
by jj portworx
can you do share how you did it? wiring, etc..