Page 1 of 1

Help reading datalog / is this safe?

Posted: Mon Dec 23, 2019 9:33 am
by brashton
Recently purchased a flashpro for my 2019 ctr and flashed the 91 octane / smoother throttle tune. Went ahead and took a few datalogs and noticed the knock detection %'s look very high (I think?) I am very green to this stuff so that caused a little alarm. It doesn't look like it's doing much knock retard, but the detection spikes up to 200% sometimes. Is this normal? Should I be worried? I've posted the same stuff on facebook but figure I may get a better response here. Links to logs below:

Tune-
https://drive.google.com/open?id=10zkxI ... x0HhiG4muL

3rd Gear-
https://drive.google.com/open?id=1W8DM1 ... rtFW9zThhQ

4th Gear-
https://drive.google.com/open?id=1R3QP7 ... H6D2Ej6qPs

Random Highway Driving
https://drive.google.com/open?id=1VIgUr ... XO1xSDRZBJ

Appreciate any input, just trying to make sure what I am doing is safe.

Re: Help reading datalog / is this safe?

Posted: Fri Dec 27, 2019 1:02 pm
by Hondata
There is no knock retard which is good. Ignore the knock control or knock level.

The fuel trims are not bad but the AF in boost looks a little jagged. I would do another datalog using the FlashPro, which gives a higher resolution datalog than using a laptop.