Can't upload secondary calibration
Posted: Mon Dec 16, 2019 5:04 pm
I've been using the Flashpro unit for a long time and for the first time I wanted to use this feature.
I'm trying to figure out if I'm doing something wrong.
I did upload the two calibrations on the Flashpro. Then I plugged it and I pressed the Datalog button. While holding it down I pressed the Program button for longer than a second, released it and then I released the Datalog button.
Nothing happened, the Flashpro didn't start flashing, none of the signs it was doing anything.
After a couple of attempts I tried uploading the Primary and it worked. Opened the Flashpro window and it does show the two calibrations being there...
Anyone can give some advice?
I'm trying to figure out if I'm doing something wrong.
I did upload the two calibrations on the Flashpro. Then I plugged it and I pressed the Datalog button. While holding it down I pressed the Program button for longer than a second, released it and then I released the Datalog button.
Nothing happened, the Flashpro didn't start flashing, none of the signs it was doing anything.
After a couple of attempts I tried uploading the Primary and it worked. Opened the Flashpro window and it does show the two calibrations being there...
Anyone can give some advice?